Download
Name VariCam Software (Firmware) Update Data
Last Update May 29, 2017
Model AU-V35C1G, AU-V23HS1G, AU-VREC1G
AU-VCVF1
Registered
Name/Size		 VSI6060Z / 144MB
VSI6043K (for AU-VCVF1 Ver 1.10) /  1.3MB
Expected Time for Update Approx. 60min
© Panasonic Entertainment & Communication Co., Ltd.
Transfer All Rights Reserved
Software This software is update data for the applicable model above.
Content  Ver 7.50-00-0.00
   CAMERA(35)：7.50-00-0.00
   CAMERA(HS)：7.50-00-0.00
   RECORDER  ：7.50-00-0.00
AU-VCVF1G Ver 1.10
  1. The lower limit of FPS setting range is extended.
    When HIGH SPEED is ON, FPS can be set from 1.

    <VariCam 35> FPS Setting Range
            So far    60-120p / 50-100p
     → Changed to 1- 120p / 1 - 100p
    <VariCam HS> FPS Setting Range
            So far    120-240p / 100-200p / 60-120p / 50-100p
     → Changed to 1 - 240p / 1 - 200p / 1- 120p / 1 - 100p

  2. REC CHECK function is added.
    Playback function of the first or last 5-second footage of the last clip recorded after the power is turned on This is used after it is assigned to a User SW.
    The following items are added for assignment to USER1 – 4 in MENU.
    - CHECK LAST CLIP START ・Playback of the first 5-sec
    - CHECK LAST CLIP END　　・Playback of the last 5-sec
  3. DESQUEEZE in playback is supported.
    Firmware is changed so that not only EE output but also a played clip is shown using DESQUEEZE when MENU -> ANAMORPHIC DESQUEEZE -> DESQUEEZE is ON.
    Varicam HS does not support ANAMORPHIC DESQUEEZE even in EE mode.
    VariCam 35 does not support DESQUEEZE in SUB-playback.
  4. CPS function is disabled.
    The CPS MENUs are disabled so that the setting, change, etc. of passwords are not allowed.
    However, if a CPS-encrypted medium is inserted into the camera, these MENUs are shown.
  5. Default setting for monitor output indication of USER CLIP NAME is changed to OFF.
    OUTPUT SETTINGS Menu
    MON OUT INDICATOR ->USER CLIP NAME（TYPE3) ->USER CLIP NAME :OFF
  6. Support for Add/Delete function of SHUTTER and WB via ROP App
    Supported App: VARICAM ROP Ver. 1.0.3 or later
  7.  Support for connection for network via the access point (Infra mode).
  8. Supported wireless LAN modules are added.
    AJ-WM50MC (China) Automatic Channel Switching
    GW-900D (PLANEX, Japan)
  9. Improvement
    The indicator for remaining card capacity is corrected because it has a problem when the format is Long GOP on 23.98p of Frequency .　

 
History of release notes
Preparation
for Upgrade		 Copy the update file of the Software (Firmware) to an SD memory card.
Software can be updated using this SD memory card.
Please refer to the procedure in the site.(Printing out of the procedure is recommended.)