Download |
Name |
AG-UX90 series Software (Firmware) Update Data |
Last Update |
Apr. 11, 2018 |
Model |
AG-UX90 series AG-UX90PJ AG-UX90PB
AG-UX90PX AG-UX90EJ AG-UX90EN AG-UX90ED AG-UX90AN AG-UX90MC |
Registered Name/Size |
DV91000002J / 58.2 MByte Expected Time for Update
Approx. 3min |
Copyright |
Copyright © Panasonic Corporation |
Transfer |
All Rights Reserved |
Software |
This software is update data for the applicable model above. |
Content |
Ver. 1.08-
Improvements
- On rare occasions, the operation of REC button on the unit or a wired remote control may no longer have any effect. This problem is fixed.
- If the card is ejected from the main slot during the simultaneous recording, the recording in the sub-slot stops 10 hours after the start of recording.
The indication shows the same as during recording, and the operations of REC button are refused. This problem is fixed.
- LCD may not show anything when the camera is booted up. This problem is fixed.
- A very few SD cards may have a write error. This problem is fixed.
- If the network address is changed when WIRELESS SETUP is set to [DIRECT] and DHCP is set to [SERVER], it sometimes made the camera impossible to connect to the iPad. This problem is fixed.
Only on "AG-UX90PJ"
- The quality of image in PM mode is changed to place importance on the resolution.
|
History or Release note |
Preparation for Upgrade |
Copy the update file of the Software (Firmware) to an SD
memory card. Software can be updated using this SD memory card. Please
refer to the procedure in the site.(Printing out of the procedure is recommended.) |