Download
Name POVCAM
Software (Firmware) Update Data
Last Update Dec. 10, 2020
Model Recorder: AG-UMR20
Camera Head: AG-UCK20
Registered
Name/Size
DV9100007_J / 79.0 MByte 
Expected Time for Update Approx. 3min
© Panasonic Entertainment & Communication Co., Ltd.
Transfer All Rights Reserved
Software This software is update data for the applicable model above.
Content Ver. 1.14-

We’ve improved the following.

  1. There was a problem in Ver.1.13 (released in December 2019) that unnecessary information was included in the response to external commands. Therefore, it could not be used with PTZ Virtual USB Driver Ver.1.1.10. This issue has been improved.

    For your reference, the application has already addressed this issue. If you use PTZ Virtual USB Driver Ver.1.4.19 (May 2020) or later, it will work regardless of the version of POVCAM.

  2. There were following issues with the display of the WEB screen. These issues have been fixed.
    (1) Unnecessary buttons are displayed when you use PreREC function.
    (2) Unnecessary buttons are displayed while accessing the SD card.
    (3) During recording, "REC" is not displayed but "P-REC / REC" by mistake.

  3. AUTO REC recording may not stop.
    When recording the SDI input video with the AUTO REC signal, if you stop recording to Card1 and switch to Card2, there was a problem that recording did not stop even if you pressed the SS button. (Press SS button again to stop properly.) 
    This issue has been fixed.

History of release note
Preparation
for Upgrade
Copy the update file of the Software (Firmware) to an SD memory card.
Software can be updated using this SD memory card.
Please refer to the procedure in the site.(Printing out of the procedure is recommended.)