| Content |
SYSTEM VERSION 01.33-000-00.00
Revision Overview
Please refer to the latest Operating Instructions for details.
- Added Native format to SYSTEM FORMAT
Related MENU BASIC CONFIG > FORMAT
[ FREQUENCY : 59.94Hz ]
2160/29.97p, 2160/23.98p
1080/29.97p, 1080/23.98p
[ FREQUENCY : 50Hz ]
2160/25p, 1080/25p
- Supports ST2110 JPEG XS
Related MENU BASIC CONFIG > OPT MODE : ST2110 JPG XS
Added related items to IP SIGNAL > ST2110 COMMON menu
- Supports LAN TRUNK (Ethernet)
Related MENU BASIC CONFIG > LAN(RJ45) MODE : TRUNK
- Added menu for fine-tuning GAMMA
Related MENU GAMMA / BLACK GAMMA
> OFFSET GAMMA : -10 to +10
- Intercom function expansion
5-1) Added a mode where the TALK destination can be switched using the hardware switch on the back of the unit.
5-2) The "Zoom Demand" PROD/ENG selection switch operation has been changed to switch the TALK destination of the INCOM1 headset.
5-3) Fixed a bug where INCOM TX/RX could not connect to ENG/PROD correctly when using ST2110/JPEG XS.
Changed the menu name to indicate whether the signal is ENG or PROD.
After INCOM1 TX (ENG) / INCOM1 RX (ENG)
INCOM2 TX(PROD) / INCOM2 RX (PROD)
- Supports 31-bit subnet mask
The IP address for LAN, SFP1, and SFP2 can now be set to 31 bits, "255.255.255.254".
- When an IP address was assigned via DHCP, the display would sometimes remain at the default setting (192.168.0.30) regardless of the valid IP address value. This has been improved.
- Fixed a problem where USB media devices formatted on the AK-UCX100 main unit could not be read on a Mac.
- Fixed a bug where the SUB VIDEO TX video was abnormal when OUTPUT SELECT was VF/RET/RET1-4 in ST2110/JPEG XS.
As a result, SUB VIDEO TX will be fixed to CAM output.
- Supports warning when the clock is not set
- Supports SFP signal level display when ST2110/JPEG XS
- Fixed a bug where the error log display on the web screen would show "CAM Sensor Error" even when there was no error
- Other minor issues have been improved.
|