|
Content |
SYSTEM VERSION 01.21-000-00.00
Revision Overview
Please refer to the latest Operating Instructions for details.
- Auto Focus Function
Phase Detection Autofocus (PDAF) makes autofocus possible even in this studio system camera.
[Related Menu]
FOCUS SETTING > FOCUS MODE: MANUAL/AUTO
AF SPEED: [1] - [10]
AF AREA SIZE: [SMALL][MID][LARGE]
AF AREA POSITION: [U.LEFT], [U.CENTER], [U.RIGHT], [LEFT],
[CENTER], [RIGHT], [B.LEFT], [B.CENTER],[B.RIGHT]
- Added a menu for skew reduction.
[Related Menu]
BASIC CONFIG > SCAN MODE: NORMAL/LOW SKEW
- Added REMOTE BACK FOCUS (Remote Back Focus RBF) Function
Back focus adjustment can be performed remotely from the ROP.
- F-drop and Vignetting Compensation (FVC)
When connecting a lens for the first time, obtains correction data from the lens. Automatically
corrects F-drop and vignetting according to the lens position.
[Related Menu]
MAINTENANCE > FVC ADJUST
SUB DISPLAY > STATUS INDICATOR > FVC
SUB DISPLAY > MODE CHECK IND > FVC
- Event Log Improvements
Event and error logs can now be output to files and downloaded to USB media from the OSD menu or to a
PC via the web screen.
- When the VF Dark Gain Function* is enabled, its status is displayed on the OSD.
*When the subject is dark and VF visibility is reduced, this function enhances the dark areas of the VF
image to ensure visibility.
[Related Menu]
SUB DISPLAY > STATUS INDICATOR > MONITOR DARK GAIN:OFF/ON
- CAM NUMBER Support
[Related Menu]
[OSD] BASIC CONFIG > CAMERA NUMBER 1-99
[WEB] Setup > System > Basic Config > CAMERA NUMBER 1-99
- Added EBU mode* to Preset Matrix
*A matrix setting based on EBU-NORMAL for AK-UC4000
[Related Menu]
PAINT > LINEAR MATRIX > PRESET MATRIX: HD/NORMAL/STD1/STD2/CINEMA1/CINEMA2/EBU/USER
- Added MODE CHECK menu
[Related Menu]
MODE CHECK
- Added USER SWITCH
[Related Menu]
SWITCH ASSIGN>LENS VTR / LENS RET1
Since the UBX100 unit itself does not have a User SW button, these functions will be assigned to
the "VTR" and "RET" buttons on the lens.
- HTTPS account (USER/HOST)/password deletion function
[Related Menu]
ACCOUNT SETTING > USER AUTH. DELETE
- Supports ST2110 RETURN signal input
[Related Menu]
ST2110 COMMON > RET VIDEO RX
12G SDI OUT2 > OUTPUT SELECT: RET
- Supports "SDI over Fiber," which converts SDI signals using SFP modules
and transmits them via optical fiber.
[Related Menu]
BASIC CONFIG > OPT MODE
12G SDI OUT2 > OUTPUT SELECT: RET
- Standby function via PC commands
Operation is limited to commands received from a PC
(Currently, standby commands from AK-HRP/AW-RP controllers are not supported).
- The following issues have been fixed:
(1) In an ST2110 redundancy environment, unstable SFP PRI connections may cause the SFP SEC video to
freeze.
(2) LAN communication is disabled when a specific subnet mask is set.
When DHCP is enabled and the subnet mask is set to anything other than <255.255.255.0>,
<255.255.0.0>, or <255.0.0.0>,.
|