Frequently asked questions, 4K Camera recorder AG-DVX200

4K Camera Recorder AG-DVX200 FAQ What is the Minimum Object Distance (MOD)? Is background record mode (perform REC start/stop with a memory card while continuously recording on another memory card) available? What is the lens size for attachable filters? What is the applicable battery? My camera cannot be switched ON since it was shut down by low battery warning. I already replaced a battery pack to fully charged one. What is the screw size for tri-pod mount adaptor? When enable the "EVF_ON/OFF" function with one of the USER buttons, image is displayed on the EVF but it goes to built-in LCD after a while… Is it intended behavior? → Click here to see the TECH BRIEF "The Benefits of Shooting in 4K, 4/3 type sensor and Fixed Lens, etc." → Click here to see the NLE Support Information LUT file application and Clip import guide, etc.
	What is the Minimum Object Distance (MOD)?
	Approx.1.0m (3.28ft) from foremost lens. It can be shorten to approx.10cm (0.33ft) at the wide-angle end by using a FOCUS MACRO function.
	Back to top
	Is background record mode (perform REC start/stop with a memory card while continuously recording on another memory card) available?
	Yes, the background record mode is available as standard. It works at FHD (1920x1080, MOV & MP4) and AVCHD record modes whose bitrate is 50Mbps or less. To take advantage of the feature of the dual card slot, following record modes are also available. - Relay - Simultaneous - Dual codec (record hi-res and low-res images on each memory card.) Notes: - For SIMUL and DUAL CODEC recordings, the same SD memory card types (SDHC or SDXC) must be used to work. - There are some unavailable record modes and formats in the record modes. Please refer to dual slot feature's pages in the operating instructions for more details.
	Back to top
	What is the lens size for attachable filters?
	72mm diameter, a size commonly used in the broadcast and professional industry.
	Back to top
	What is the applicable battery?
	Part No.VW-VBD58 (5800mAh) is applicable. VW-VBD55 (5400mAh) cannot be used with the AG-DVX200.
	Back to top
	My camera cannot be switched ON since it was shut down by low battery warning. I already replaced a battery pack to fully charged one.
	When camera was shut down with low battery, please turn power SW OFF before replace a battery pack, and turn power SW ON after a battery pack is mounted otherwise there could be a case that the unit does not power ON.
	Back to top
	What is the screw size for tri-pod mount adaptor?
	Following two different holes are arranged. - 3/8-16UNC - 1/4-20UNC * Please use screws shorter than 5.5mm in length otherwise it may cause significant damage to the unit.
	Back to top
	When enable the "EVF_ON/OFF" function with one of the USER buttons, image is displayed on the EVF but it goes to built-in LCD after a while… Is it intended behavior?
	Yes, it is. In order to protect OLED EVF device against image sticking, display device will be switched from the EVF to the LCD when the built-in proximity sensor (located in the EVF) detects nothing for a few seconds.
	Back to top

FAQ