Mac Windows UB300 Setting Tool  
 
UB300 Setting Tool
UB300 Setting Tool is dedicated for AK‑UB300G. This operates in Windows and Macintosh.
Changing of the setting menu and updating of the firmware for AK‑UB300G are possible.

UB300 Setting Tool

 

Ver 1.16 October 25, 2017 :AK-UB300 Ver.7.52 is supported.

Perform the installation logged in as a user with the administrator privilege.

  1. Double-click the downloaded file. The file is expanded and setup.exe is displayed.
  2. Double-click setup.exe. The introduction screen is displayed. From hereafter, install following the instruction of the installer.
    A restart may be required depending on the environment of the personal computer. If so, use the UB300 Setting Tool after restarting the personal computer

UB300 Setting Tool

Ver 1.16 October 25, 2017 :AK-UB300 Ver.7.52 is supported.

Perform the installation logged in as a user with the administrator privilege.

  1. Double-click the downloaded file. The file is expanded and UB300SettingTool.app is displayed.
  2. Move UB300SettingTool.app to the Application folder. Move to appropriate location as necessary.
　　
LAN connect the personal computer to operate the UB300 Setting Tool and AK-UB300G.
You can operate following functions.
  • Connection Setting
    • Set up for IP Address, Port NO. and etc.
  • Firmware Update
  • Main Menu Operation
    • SWITCH MODE
    • PAINT
    • SYSTEM MODE
    • IN/OUT SELECT
    • FILE
  • OSD Menu Operation

 (Example) When the PAINT menu is selected.