| Content |
SYSTEM VERSION 1.27
New Function
- PDAF (Phase Detection Auto Focus) functionality has been added.
Employing a method of combining image plane phase-difference detection AF and contrast AF.
- Focus Guide function has been added.
When the manual focus is set, the icons are displayed to indicate the focus state of the area you have touched.
- "2160/60p" (JUST) has been added to the system format.
- 4K color bar TYPE4/TYPE5 have been added to "COLOR BAR TYPE"
• TYPE4 :ARIB (UHD)
• TYPE5 :ARIB (2020/HLG)
- "Down conversion from UHD to FHD" has been added to NDI (High bandwidth NDI) output format.
- IP distribution can be used when the system frequency is 60Hz (JUST).
- "Fixed IP address" has added for [USB] setting.
"DHCP" or "Fixed IP" can be selected like as [LAN] and [SFP+].
- WEB screen status display has been added.
ST2110 RX (RETURN) format information (Format/Framerate), G/L sync information display.
- A selection item of REF SIGNAL has been renamed.
Related menu: BASIC CONFIG - SYNC SIGNAL - REF SIGNAL
The selection item "SDI" has been changed to "BBS/TRI-LEVEL SYNC"
- A new Digest authentication mode has been added "Wait time mode".
When using a Panasonic controller (AW-RP150, AW-RP60), set [Wait time mode] to [Mode2] when using digest
authentication.
[Mode1] (Initial value) This is the setting recommended if security is to be prioritized.
[Mode2] The wait time for re-entry is shorter. This is the setting recommended if operability is to be
prioritized.
- IRIS-related information can be saved in SCENE files.
• The following items in PICTURE - IRIS have been added to the backup target of the SCENE file.
AUTO IRIS, WINDOW SELECT, PICTURE LEVEL, PEAK RATIO, AUTO IRIS CLOSE LIMIT, IRIS SPEED
• If you want to update so that the IRIS setting value is not initialized before and after the update,
save the SCENE file by either method (2) or (3).
In method (1), each item of IRIS is initialized.
(1) Load the SCENE file (OSD menu: FILE - SCENE FILE) that was saved with the camera before the update with the camera after the update.
(2) Download a SCENE file to the camera before the update. (Web screen: Maintenance - Backup) Upload the SCENE file to the camera after the update.
(3) Store a SCENE file on the SD card of our controller (RP150/RP60) before the update. (Controller side menu: MAINTENANCE - FILES) Load the SCENE file with the camera after the update.
Improvements
- When using the FP+ terminal, H.264/H.265 UHD/75Mbps distribution and HTTP communication (access to web screens, etc.) cannot be performed.
- PTP synchronization function has been improved to operate without delay according to PTP domain settings.
- Operational stability has been improved under special conditions*. (*Continuous switching between power ON/OFF, Format, 50Hz/59.94Hz, etc.)
- Values over 50000 can be set correctly for Destination port of ST2110.
|