We’ve added the following.

1. AW-UE4 has been supported. You can now control the image adjustment menus of AW-UE4.
   　 　Related menus
   　　PAINT MENU,
   　　FUNCTION > CAM INFO
2. The camera linkage function "EXT CONT" menu has been changed. It is no longer necessary to set EXT CONT and Ext IP individually for each CAM SEL. When EXT CONT is turned ON, the position of the rail system set to Ext IP can be controlled regardless of the combination of CAM SEL and EXT CONT settings.
   　　SYSTEM  >  EXT CONTROL  >  CAM SEL
   　　　　　　　　　　　　　　　 >  EXT CONT
   　　　　　　　　　　　　　　  >  Ext IP　
3. The operability of the rail system preset settings has been improved, such as the ability to automatically acquire preset status information.
   　　SYSTEM  > EXT CONTROL　
   　　　 > EXT PMEM "ON/OFF" of the rail system preset settings
   　　　 > RSV PORT　Port number of the rail system
   　　  > PMEM/TMEM  > EXT CNT PRESET Status information can be updated automatically.
4. Simultaneous operation of rail system position control has been supported.
   　　SYSTEM  > EXT CONTROL
   　　  > LEFT　/  >  RIGHT /  >  SPEED,
   　　  > UP /  >  DOWN /  > SPEED
5.  The camera selected from the PTZControlCenter application software (Ver.1.5.19 or later) via the AW-RP150 can be controlled.

• Rebooting after this update will take longer than after a previous update. You can check the progress by turning on the button on the main unit. Please be careful not to turn off the power during the process. 　
• First, the 10 camera selection buttons light up in blue. Gradually turn it off as the process progresses.