Download |
Name |
Software(Firmware) Update Data |
Last Update |
Oct. 11, 2018 |
Model |
AK-HRP1005G AK-HRP1005MC |
Registered Name/Size |
VSI6301K /774KByte |
|
© Panasonic Entertainment & Communication Co., Ltd.
|
Transfer |
All Rights Reserved |
Software |
This software is update data for the
applicable model above. |
Content |
Firmware Version |
|
SYSTEM VERSION |
4.60-00-0.01 |
SOFT VERSION |
4.60-00-0.01 |
FPGA VERSION |
1.00-00-0.00 |
- Controlling AJ-PX5000 camcorder via serial connection using AK-HRP1005
is enabled.
- Linkage with AV-HS6000
AV-HS6000 communicates with ROP when TALLY
is turned ON/OFF at AV-HS6000. ROP communicates TALLY (RED) information
to the configured camera. Linking the Unit to the AV-HS6000 Related menu: SWITCHER LINK:
TALLY RECEIVE AV-HS6000 Plug-in: "External Control"
This is a function available when equipment other than studio cameras
is connected.
- Linkage with AV-HS6000
ROP communicates with AV-HS6000 when Preview
button on ROP’s PANEL is pressed. When AV-HS6000 receives the information,
it runs the macro recorded via "Macro Trigger IP" plugin to execute
BUS switching, etc. Linking the Unit to the AV-HS6000 Related menu:SWITCHER LINK: PREVIEW
AV-HS6000 Plug-in: "Macro Trigger IP"(new plug-in) This
is a function available when equipment other than studio cameras is
connected.
- HS format is suppurted.
Correction is made so that FORMAT RATE
command is sent together when, from ROP and MSU, FORMAT commands are
sent to the camera and CCU. (No change in menu indications.
Correction to the internal control only.)
- The following item is added to HDR PAINT menu.
SDR CONVERT :
”BLACK”(BLACK OFFSET) However, this parameter is available
for AK-UC4000 only, and shown as “ー” on the others.
- A menu is added so that TALLY input can be checked at the
contact point.
This is for making this check possible with ROP only
without the camera This is a function available when equipment other
than studio cameras is connected. SYSTEM CAM : TALLY
SIGNAL
|
History of Release note |
Preparation for Upgrade |
Copy the update file of the Software
(Firmware) to an SD memory card. Software can be updated using this SD
memory card. Please refer to the procedure in the site.(Printing out
of the procedure is recommended.) |