Content |
Firmware Version |
|
SYSTEM VERSION |
4.60-00-0.00 |
SOFT VERSION |
4.60-00-0.00 |
FPGA VERSION |
1.01-00-0.00 |
- Controlling AJ-PX5000 camcorder via serial connection using AK-HRP1000
is enabled.
- Linkage with AV-HS6000
AV-HS6000 communicates with ROP when TALLY
is turned ON/OFF at AV-HS6000. ROP communicates TALLY (RED) information
to the configured camera. Linking the Unit to the AV-HS6000 Please refer to the "Linking the Unit to the AV-HS6000" for details. Related Plug-in: "External Control"
This is a function available when equipment other than studio cameras
is connected. (VariCamLT, etc.)
- Linkage with AV-HS6000
ROP communicates with AV-HS6000 when Preview
button on ROPfs PANEL is pressed. When AV-HS6000 receives the information,
it runs the macro recorded via "Macro Trigger IP" plugin to execute
BUS switching, etc. Linking the Unit to the AV-HS6000 Please refer to the "Linking the Unit to the AV-HS6000" for details. Related Plug-in: "Macro Trigger IP"(new plug-in) This
is a function available when equipment other than studio cameras is
connected. (VariCamLT, etc.)
- HS format is suppurted.
Correction is made so that FORMAT RATE
command is sent together when, from ROP and MSU, FORMAT commands are
sent to the camera and CCU. (No change in menu indications.
Correction to the internal control only.)
- The following item is added to HDR PAINT menu.
SDR CONVERT :
hBLACKhiBLACK OFFSETj However, this parameter is available
for AK-UC4000 only, and shown as g[h on the others.
- A menu is added so that TALLY input can be checked at the
contact point.
This is for making this check possible with ROP only
without the camera This is a function available when equipment other
than studio cameras is connected. (VariCamLT, etc.) SYSTEM CAM : TALLY
SIGNAL
|