AG-HPX600 series Ver 18.05
AG-YDX600G/MC Ver 2.06
These are supported with the firmware.

1) Support for UPLINK device (LiveU "LU40" series)

  Optional Upgrade Software Key AG-SFU603G/MC are required.
  (UPLINK device control function for AG-HPX600 series)

2) Support for proxy recording mode "LOW 2CH MOV" on 720P mode
 To enable this feature
  i)Install AG-YDX600 series (optional video encoder board) in AG-HPX600.
  ii)Update the fimware of AG-HPX600 and AG-YDX600.
   (To confirm the version of AG-YDX600
  MENU : DIAGNOSTIC >>　PROXY SOFT　2.06-00-0.00)

3) Change to enable ON/OFF setting for displaying the start message of PROXY recording on View Finder
4) "BATT STAT" has been added to the menu items.
  MAIN MENU => BATTERY SETUP =>BATTERY SELECT:
  Change to enable setting near-end and end thresholds for battery charge level on a percentage basis
5) Change to maintain "REC FORMAT", if "SYSTEM MODE" is changed.
  (It was initialized to AVCI-100 in HD, to DVCPRO50 in SD before.)
6) Change to enable setting White Clip Level by 1% between 100% and 109%
7) Change to enable ON/OFF setting of OSD display for AWB Color Temperature
8) Change to enable selecting from 3 levels of ATW Control Speed
9) Change to enable setting a White Balance variable value using the USER button and Jog Dial button
10) Change to enable assigning “FOCUS ASSIST” to “RET SW”
11) Change to enable selecting from color bar patterns of "FULL BARS", "SMPTE" and "AUTO SEL"
12) Change to prevent “REC REVIEW” from cancelling “D.ZOOM” or “FOCUS ASSIST”