Download
Name Driver Software(Firmware) Update Data
Last Update Sep,28, 2007
Model AJ-HPX2000,AJ-HPX2100
Registered
Name/Size		 VSI4757E/32.4MByte 
© Panasonic Entertainment & Communication Co., Ltd.
Transfer All Rights Reserved
Software This software is update data for the applicable model above.
Content
  • The update process has been made more reliable.
The following contents is included.
  1. 16GB P2 Card compatibility
  2. AVC-Intra Codec recording and playback.
    *Installation of AJ-YBX200G (AVC-Intra Codec Board) is required.
  3. Native 24P, 30P, 25P recording
    Native 24P, 30P (at 59.94Hz) and 25P (at 50Hz) recording works as follows.
    *The rate is pulled down to 59.94 or 50 frames rate during playback.
    *24PN(Native) proxy recording * AJ-YAX800G (Video Encoder Card) is required.
    This function requires updating the firmware of AJ-YA800G/MC.
  4. INTERVAL REC function
    “Interval recording function” and “One Shot recording function” are introduced.
  5. ”CHROMA LEVEL” menu can be controlled by AJ-RC10G/MC.
    ”CHROMA LEVEL” menu is introduced as a combined menu of “TOTAL CHROMA G” menu and ”CHROMA OUTPUT” menu.
    Please refer to the following NOTICE about MENU DATA back up.
NOTICE
The setting value of CHROMA GAIN and CHROMA OUTPUT are not been taken over because the menu structure has been changed with this update.
  • So if the version of the items is as below, you need to do below 3 steps when you update the software.
  • CAMSOFT MAIN Ver.1.06-00-0.00 or lower
  • CAM TABLE Ver.3.00-00-0.00 or lower
  • Step1: Write down the setting value of the below item in Menu if each value is different from the value below.
  • TOTAL CHROMA GAIN ：+00%
  • CHROMA OUTPUT ：ON
  • If the setting is as same as above, Step1 and Step3 are not needed.
  • Step2: Update the software firmware
  • Step3: After finishing update, change the setting for the menu item below.
  • MAIN MENU －PAINT －KNEE/LEVEL
  • CHROMA LEVEL :
Please refer to the procedure in the site.
Preparation
for Upgrade		 Copy the update file of the Driver Software (Firmware) to an SD memory card.
Software can be updated using this SD memory card.
Please refer to the procedure in the site.(Printing out of the procedure is recommended.)