Download
Name Software(Firmware) Update Data
Last Update Oct. 9, 2018
Model AK-HC5000G/GS
AK-HC5000MC/MS
Registered
Name/Size
VSI6140S /32.0MByte
© Panasonic Entertainment & Communication Co., Ltd.
Transfer All Rights Reserved
Software This software is update data for the applicable model above.
Content
Firmware Version  
CAM MAIN 4.27-
NETWORK 3.01-
ROM TABLE 1.01-
CAM FPGA 8.01-
AVIO FPGA 8.34-00-F.00
INCOM FPGA 3.01-

The following problems are fixed.

  1. If the menu button is pressed repeatedly right after the camera is booted up, the menu screen may not be displayed.
  2. If AUTO SET UP (ASU) is executed, the SHUTTER value may not be the one appropriate for the set format.
     • If 59.94i/59.94p format is set, the SHUTTER value may be, for example, 24.1 Hz. (The normal range is from 61.7 to 6,130 Hz.)
     • Even if the format is changed from 60 Hz to 50 Hz, the SHUTTER value will not be converted. (After 1/120 SHUTTER for 60 Hz is stored in a user file, if the format is changed to 50 Hz, it is normal that SHUTTER should be converted to “1/125” and loaded. But, actually, it remains “1/120”.)
  3. The on-screen indication for DETAIL SETTING will not change according to the switching operation between HD and UHD formats via CCU. (Normal indication is “DETAIL: ON (or OFF)” in HD format and “---“ in UHD format.)
  4. It is normal that G GAIN AWB should be “0” when both RGB GAIN ABS DISP SWITCH (function to display RGB Gain with an absolute value) and G GAIN REL CONTROL SWITCH (function to control Gch Gain with a relative value) are set to ON. But it will not be applied to the G GAIN AWB indication on the ROP.
  5. On MODE CHECK screen, the setting values of GRIP RET (function to switch the return signal via RET button on the grip) and GRIP PTT (function to switch the intercom mic ON/OFF, etc.) are replaced with each other.
  6. IP streaming image is shifted upwards when it is output.

History of Release note
Preparation
for Upgrade
Copy the update file of the Software (Firmware) to an SD memory card.
Software can be updated using this SD memory card.
Please refer to the procedure in the site.(Printing out of the procedure is recommended.)