| Download |
| Name |
AU-EVA1 series Software (Firmware) Update Data |
| Last Update |
Jan. 11, 2018 |
| Model |
AU-EVA1 series
AU-EVA1P AU-EVA1PJ
AU-EVA1EJ AU-EVA1EN AU-EVA1ED AU-EVA1AN AU-EVA1PX AU-EVA1MC |
Registered
Name/Size |
DV91000107H / 29.7 MByte
Expected Time for Update
Approx. 3min |
|
© Panasonic Entertainment & Communication Co., Ltd. |
| Transfer |
All Rights Reserved |
| Software |
This software is update data for the applicable model above. |
| Content |
Ver. 1.10-
Improvement
- When the HDMI output is connected to BT-LH1850 monitor and displayed
on it, once the monitor’s input setting is switched to SDI, "No
Signal" is shown and no image will be displayed any more even if
the setting is put back to HDMI. This problem is fixed.
- Display of SENSOR TEMP at low temperatures is improved.
- Panning at high speed may cause ghosting. This problem is fixed.
- Focus Assists are not displayed on the SDI output destination when
the LCD panel is disconnected. This problem is fixed.
- An image on the LCD is defective when Open Iris F. A. is enabled.
This problem is fixed.
- Error in information superimposed on SDI (payload) at 24.00 Hz is
corrected to 60.00.
- Even if the Wi-Fi setting is switched from INFRA to DIRECT, the
display of IP address will not change. This problem is fixed.
- The camera cannot connect to Wi-Fi using D-Link DWA-171 (For Australian
Market). This problem is fixed.
|
| History or Release note
|
Preparation
for Upgrade |
Copy the update file of the Software (Firmware) to an SD
memory card.
Software can be updated using this SD memory card.
Please
refer to the procedure in the site.(Printing out of the procedure is recommended.) |