New Features

1. The V-log mode was added to the gamma settings.
   The same LUT can be applied to VariCam, AU-EVA1, AG-CX350/CX200 and AJ-CX4000/UPX900.
2.  USB tethering function has been added.
   NETWORK > DEVICE SEL > USB TETHERING
   
   You can use the USB tethering function of smart phones to connect the camera to the Internet.
   (5G line can be used depending on the smart phone specifications.)
3.  A menu for confirming network connection has been added.
   NETWORK > UTILITY > NET CHECKER
   You can also save the check result file in the following folder.
   　¥PRIVATE¥MEIGROUP¥PAVCN¥SBG¥P2SD¥netchk.txt"
4.  Linkage with CX ROP application software. Camera search function has been added.
   All cameras in the same network are listed.
   You can select a camera from the list and connect to the camera without entering the IP address.
5.  RTMP streaming service "Azure Media Services" and "Twitch" have been supported.
6.  Firmware of the HD color VF "AJ-CVF25" or "AJ-CVF70" can be updated via AJ-CX4000/UPX900.
7.  New mode “FBC2” has been added.
   When the Flash Band Correction function (FBC) is enabled, minute colored line noise may occur on the corrected line. "FBC2" mode minimizes this phenomenon.
   
   By pressing the USER buttons that are assigned with the flash band compensation function, the function turns on, and flash strobe from a still camera, etc. can be detected and compensated.
   You can select and use the functions according to your needs.
   FBC1 (conventional FBC)
   FBC2 (colored line noise reduction mode)
   In [FBC2] mode, flash band image tend to appear more compared to [FBC1] mode.
   When shooting a fast moving subject or when moving the camera rapidly during pan shooting,
   the subject may be shot slightly inclined.
   
   Please refer to the latest Operating Instructions for more details.
   
   
     Note
     When you use FBC2 mode, perform Black Shading adjustment before using it.
      Black Shading Adjustment Procedure
   
     However, depending on the manufacturing time of the camera, the adjustment may not be necessary because it has already been performed.
     It can be identified by the upper 2 digits of the serial number of camera.
     ・If the serial number is the following, Black Shading adjustment is required.
          L9--,A0--,B0--,C0--,D0--
     ・If the number is "E0" or later in the order of “ABC…”, this adjustment is NOT required.
          E0--,F0--,….

Improvement

1.  When the power of the camera was turned on with the LCD panel closed, the VF ZEBRA switch might not work. This issue has been fixed.
2.  In rare cases, playing clips may stop under certain conditions.
   This issue has been fixed."