CX350

Name

AG-CX350 series Firmware Update Data

Last Update

Jul. 29, 2019

Model

AG-CX350 series, AG-CX200MC,AJ-UPX360MC

Registered
Name/Size

DV91000240F / 38.9 MByte
Expected Time for Update Approx. 5min

Transfer

Software

This software is update data for the applicable model above.

Content

Ver 1.11-

New Features

New Wireless Module AJ-WM50G* is supported.
（*AJ-WM50G is available on 2.4GHz only. It can be used only in the country or region where they are supported. In addition, the launched schedule varies according to the country or region.

Improvement

When you use a wired controller that was connected to the “REMOTE” terminal, the zoom speed will be faster than the degree of your operation.
This problem is fixed.
In the scene file menu, the detail frequency (DTL_FREQ) and the level dependent (LEVEL_DEPEND) may not change correctly depending on the setting values.
This problem is fixed.

History of release note

Preparation
for Upgrade

Copy the update file of the Software (Firmware) to an SD memory card.
Software can be updated using this SD memory card.
Please refer to the procedure in the site.(Printing out of the procedure is recommended.)

Download
Name	AG-CX350 series Firmware Update Data
Last Update	Jul. 29, 2019
Model	AG-CX350 series, AG-CX200MC,AJ-UPX360MC
Registered Name/Size	DV91000240F / 38.9 MByte Expected Time for Update Approx. 5min
	© Panasonic Entertainment & Communication Co., Ltd.
Transfer	All Rights Reserved
Software	This software is update data for the applicable model above.
Content	Ver 1.11- New Features New Wireless Module AJ-WM50G* is supported. （*AJ-WM50G is available on 2.4GHz only. It can be used only in the country or region where they are supported. In addition, the launched schedule varies according to the country or region. Improvement When you use a wired controller that was connected to the “REMOTE” terminal, the zoom speed will be faster than the degree of your operation. This problem is fixed. In the scene file menu, the detail frequency (DTL_FREQ) and the level dependent (LEVEL_DEPEND) may not change correctly depending on the setting values. This problem is fixed.
Content	History of release note
Preparation for Upgrade	Copy the update file of the Software (Firmware) to an SD memory card. Software can be updated using this SD memory card. Please refer to the procedure in the site.(Printing out of the procedure is recommended.)